Product Categories
ZJ-BC02
Charging interface mechanical load test device
Keywords:
Product Description
I. Overview
This equipment can perform mechanical load tests on the charging gun interface to meet the test requirements of standard GB/T20234.1-2023 Clause 6.2.10.7, Clause 7.11.8, and Clause 7.30.
II. Usage Environment
| 1 | Ambient temperature | 5～35℃ |
| 2 | Ambient humidity | 85%R.H 25℃ |
| 3 | Atmospheric pressure | 86～106Kpa |
| 4 | Environmental conditions | The equipment should be free from strong vibration, strong electromagnetic interference, high concentrations of dust and corrosive substances, direct sunlight or other direct radiation from heat sources. |
| The equipment should be placed horizontally in a well-ventilated laboratory, with sufficient space around it for operation and maintenance. |
III. Complies with the following table
IV. The equipment meets the requirements of Figure 5 and Figure 7
Main technical parameters
| Serial number | Technical parameters |
| 1 | The equipment meets the gravity load requirements of Table 7. The gun seat can be manually rotated 90 degrees, and the cylinder lifts and releases the weight, and the force is automatically timed. |
| 2 | Control device: cylinder, PLC, touch screen |
| 3 | Equipped with national standard, European standard, and American standard gun mounts and fixing plates. |
| 4 | The power supply plug or vehicle plug is a finely ground contact made of hardened steel. The surface roughness of the contact over its working length does not exceed 0.8μm, and the spacing is the nominal distance with a tolerance of ±0.05mm. For other types of pins, the dimensions of the pins or the distance between the pin surfaces shall comply with the minimum dimensions given in the relevant standards, with a tolerance of +0.01mm and 0mm (no negative tolerance). |
| 5 | The total weight of the test power plug or test vehicle plug, clamping device, load-bearing device, main weight and additional weight shall apply the pull-out force specified in Table 7. The weight of the additional weight shall be such that the force applied by it is equal to one tenth of the pull-out force. Hang the main weight on the test plug without shaking, and then drop the additional weight from a height of 5cm onto the main weight. |
| 6 | The gun seat can be manually rotated 90 degrees, 180 degrees, and 270 degrees. |
| 7 | The fixed position of the gun seat can be adjusted manually in height, and the height distance can be adjusted from 0.5m-1.5m. |
| 8 | Meet the tensile requirements specified by the 100N, 165N, 300N, 440N, 660N, and 750N combinations, and can be continuously applied for more than 1 min |
| 9 | Automatic force application timing: 0~999.9s |
| 10 | Automatic counting of force application times: 0~999 |
Online Consultation
Get prices and free samples now!
Dongguan Zhongjia Testing Equipment Technology Co., Ltd
86135 8080 6147(Technical Director)
86135 8090 9432(Mr. Guo, Manager)
Building 1, Guanghui Zhigu, No. 86, Yinkang Road, Hengli Town, Dongguan City
Add WeChat
Copyright © Dongguan Zhongjia Testing Equipment Technology Co., Ltd All Rights Reserved All rights reserved.
Power by:www.300.cn | SEO | Privacy Policy